|
|||||||
| Memberlist | Forum Rules | Search | Today's Posts | Mark Forums Read |
| Search Forums: | Click here to use Advanced Search |
Topic Review (Newest First)
|
|
|||||||
| Memberlist | Forum Rules | Search | Today's Posts | Mark Forums Read |
| Search Forums: | Click here to use Advanced Search |
|
Topic Review (Newest First)
|
| 29-05-2009 10:36 PM | ||
| Eagle of Fire | If everything mentionned above fails, you could begin to think about a hardware failure and try to reposition your screen directly from its own menu... | |
| 28-05-2009 06:48 PM | ||
| The Fifth Horseman |
output=ddraw fullresolution=whatever your desktop resolution is |
|
| 28-05-2009 05:25 PM | ||
| Japo |
Quote:
Edit the .conf file and try a different value in "output=..." |
|
| 28-05-2009 04:07 PM | ||
| Buddha |
Vertical screen position too high in full screen mode Suddenly, whenever I run in Full Screen mode, the display is misaligned upwards by about 3/4 inch. The information is still there, since I can move the mouse pointer off the top of the screen and access pull-down menus for example. I just can't see it. If I run windowed, everything is fine. I can't seem to locate any entries in the .conf file to address this, and I hesitate to make any changes in there without knowing what I'm doing. Any suggestions? Thanx, Buddha |
|
